Alcatel-carrier-internetworking-solutions Omni Switch/Router Manuel d'utilisateur télécharger pdf (Page 51)

Omni Switch/Router Chassis and Power Supplies

Page 1-21

Grounding a Chassis

Omni Switch/Routers have two grounding screw holes on the back of the chassis. These

holes use 10-32 screws and are approximately 1 inch apart. In addition, these holes do not

have paint and are surrounded by a small paint-free rectangular section, which provides for a

good connection contact.

The figure below shows the location of the grounding screw holes on the back of an

OmniS/R-9. They are located approximately four (4) inches from the bottom of the chassis

and approximately one (1) inch from the left-hand side of the rear of the chassis.

Grounding Screw Holes on an OmniS/R-9

On an OmniS/R-5, the grounding screw holes are located approximately one (1) inch from

the bottom of the chassis and approximately one (1) inch from the left-hand side of the rear

of the chassis.

On an OmniS/R-3, they are located approximately four (4) inches from the bottom of the

chassis and approximately one (1) inch from the left-hand side of the rear of the chassis.

Lifting Handle

Grounding Screw Holes

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 109 110

Pas de commentaire

Alcatel-carrier-internetworking-solutions Omni Switch/Router Manuel d'utilisateur Page 51